Month: November 2020

Since a lot of costumers are needing a guide for installing the light buckets in many RCs, we will focus this post in an exact model “ARRMA FELONY”, this guide is suitable to any RC light bucket that we sell. Not all the light buckets requiere cutting the body, in this example we will guide you through the “Cutting or Drilling a hole” instead of removing the paint and placing the bucket right behind the body without cutting anything. If you are looking for a guide about installing the lights without cutting the body, please look for the post “Install Light Buckets without cutting the body”… ok, let’s get started.

Here you will find some external guides about the different techniques for cutting and drilling your body shell:

 

Updated post here https://polocreations.com/blogs/news/using-the-splitter-or-mini-power-supply-board

As you can see, this is a very simple step, you have to connect one of the ends directly to the receiver, any free channel will work. Make sure to connect positive and negative according to the marked + and – (positive and negative). All Traxxas Receivers have a small mark that tells you where positive, negative and signal wires should be connected. The best and easiest way is to follow the same alignment as the other cables.

In the other end, you have to connect the lights, the plug has 3 outputs, you can connect up to 3 sets of lights, if you purchased (or if it comes with your kit) the splitter, you can connect as many lights as you want, the controller is very powerfull and it can take up to 600 led lights simultaneously.

Updated post here https://polocreations.com/blogs/news/using-the-splitter-or-mini-power-supply-board

As you can see, this is a very simple step, you have to connect one of the ends directly to the receiver, any free channel will work. Make sure to connect positive and negative according to the marked + and – (positive and negative). All Traxxas Receivers have a small mark that tells you where positive, negative and signal wires should be connected. The best and easiest way is to follow the same alignment as the other cables.

In the other end, you have to connect the lights, the plug has 3 outputs, you can connect up to 3 sets of lights, if you purchased (or if it comes with your kit) the splitter, you can connect as many lights as you want, the controller is very powerfull and it can take up to 600 led lights simultaneously.